schizophrenic

The test result are the same with both applications installed, only signblazer installed and without any aplication installed.

Quick Response This movement don't draw or cut any line, like i tell before, just move there. To move the head to a normal posotion , i have to press the reset button after this movement.

MH721, Windows XP PRO SP2, Serial, SignBlazer 06> The refine was working perfectly until i try to install flexisign. After the first job, the only good cut, start to draw this pattern attached with flexising, then did a test using signblazer, the sofware working good since i buy the MH721 in March 15, 2008, the result is the same problem. Since yesterday i am searching and reading for posible solutions like the ground, baud rate, port, static, configuration, communication type or media, etc... and nothing that i read has solve the problem. I notice when i press the test button, the test is not completed, only draw or cut a line and then stop the head at the end of the line. I realice a search about and nothing help. I appreciate any help