Kristy

I'm not sure how to post a file on here so let me know.... i really think it's just an issue with the settings more than anything... I'm just not familiar enough with this software.... On the computer screen the whole image (which is a group of letters) is shown physically off the top edge of the image of the vinyl on the screen... the weed box is stretched out that far too.... I tried to go ahead and cut and it cut that way too.... it began the cut in the past the middle of the vinyl just like it was shown on the screen.....

Thanks for the welcome! Sorry to rush and lack of info on this but I'm leaving for a show in less than 24 hours and I'm trying to hurry.... I'm tryin to crunch the learning curve.......... I've been using a Roland cx-24 until today.... there were problems with it so I had to replace it.... The main reason for needing all of my stuff to be in a specific order is because when the software rearranges it there is a LOT of wasted vinyl..... a whole LOT!.... I did my layout tight to prevent wasting any vinyl I'm using a MH721 with Signblazer software.... Any info will be greatly appreciated!

Primarily small single letters and 3 letter monograms.....

I'm looking for a small desktop size cutter under $500.... I've heard good and bad ........ I would just like opinions on the Craftrobo cutter? Is it worth buying? Any know problems or limitations???

Thanks SO much.... Yes.... I am using signblazer.... Fixed one prob now have another one.... I clicked off all of the save space tabs and it stopped the machine from rearranging my text blocks but now the image is moved off the side of the cutting area.... how do I move it back down?

I have several lines of text that need to be cut in order .... I arrange them in the software program but when I send them to the cutter they are rearranged in a different order... I can't put them all in the same text block because they are different sizes.... how do I keep it from rearranging things??? I'm sure it's some simple setting but I don't have time to search for the answer... I'm in a hurry....