keith

Thanks folks for the ideas.

I have been cutting simple decals for local dirt racers for a year now, mostly to support my on dirt racing forum DirtRaceFans.com. This year, some drivers have ask me to cut the vinyl for their entire car. My question is where do I find basic car tempelates for these older model mostly american made cars to use as a background to show my design? Sorry if this is in the wrong place. Keith

Great and Thanks. Got me out of the foggy and going. I know there is still much to learn but I can atleast set my machine up and do some simple cuts now which I could not before

You the one Skeeter, looked for something like that. Tried one about beginner and it took me to another site and Norton began to choke on the virus attempts. Btw it is sticked or pinned as a recommendation. But thanks I am now down to adjusting pressure and I will have my first vinyl cut circle. Bet I keep that dang circle for ever. LOL Thanks again

just bought the USCutter SC model and am so new I have no clue how to get the blade in right. It comes with a rubber cap, do I leave that on? If i take it off the blade slide up in the spring so far it barely shows as the other end slide up into the spring. LO I know this is dumb but HELP!

ok got the port working and communications going with Signblaster pro trial version. It still isn't cutting the head only moves a small distance, but that is better than where I was last night. The SC model instruction told me which Creation replacement cutter to select during the setup. Signcut pro still does not have the USCutter SC model to select nor the Liyu either so guess I'll have to wait till Monday to contact support about that. Now going to look for some advise on setting the cutter and find out why it isn't moveing across the vinyl to cut in Signblaster.

Yea, I yesterday around 6pm think they were on the west coast USA. Guess not the service said non business hours. Skeeter, going to go try these things right now. Thanks guys, hope they work, would love to waste some vinyl this weekend practicing. LOL

just purchased my uscutter sc series. Frankly the out of box experience is not good. We want go into the issues that I have resolved but, I installed signcut pro and registered it just fine. However during the initial screen it ask for my cutter. No selection for the SC model, also it ask for a port, I have usb, guess what, no usb option. I check for updates and it tells me I have the lates. I see some drivers on the site and download them but see no method to install them. Am I suppose to install it as a windows device first maybe? Flexi10 came with it, guess what, it fails on install with "page errors." Now I am 60yrs old been in the IT field for 40yrs. I know alittle about this type stuff, but is beyond bad. HELP please, I only have about 6 or 7 hairs left to lose. Thanks keith