Local So. Cal supplier

[Local So. Cal supplier]

http://www.signsupply.com/

van nuys

[Signcut vs. Signblazer]

i like using signcut a lot better as well, but how come when i choose precision cutting, it freezes? (im using demo mode by the way) will this feature work on a full version? thanks

[Cutter Stops Cutting]

Hi,

I am having a similar problem. I am using FlexiSign 7.6. I have been using it for over a month and now all of a sudden, I have been getting these "write port error" messages. I have tried a new usb cable and also trying different usb ports as well. I have had my laserpoint over a little over 2 months. I am going to do more investigating to figure out what the issues really is.

[Newbie...Getting a write port error?]

hi, it didn't work for me, but im still investigating and trial and error. :bang:

[Laserpoint blade offset setting?]

I have tried adjusting this as well, I don't see it fixing the problems. My laser point plotter will not cut my block fonts clean. The corners are rounded vs. a nice 90 degree cut...A lot has been mentioned regarding offset, but still no success. How about overcut?

[Blade Pressure, Speed, Offset, etc.]

hello,

even with adjustments, I don't see improvements. I will post pics, hopefully it will narrow things down.

If its a software problem, I am determine to get to the bottom of it.

thanks-

[Drivers to get it to work w/ flexi?]

yes, fixed. :well done:

[Laserpoint blade offset setting?]

so..how is this offset adjusted.

[Blade Pressure, Speed, Offset, etc.]

Hi,

My O's are not completing when being cut, I notice a lot was mentioned about the offset. I can't seem to find where in the sign blazer to adjust it...

Can this be adjusted within the laserpoint's options? Most text that I am cutting don't seem sharp as well. Let's say block letters...the corners are not sharp. I should post pics.

let me know whats up. thanks-

[Hi From CT Newbie here]

What are the red push buttons on each side do? It's some type of stopper for the cutter itself? My laserpoint 24 seems to freeze. :notsure: Still playing with it to work properly. how's yours doing? Maybe I should have just got the copam 24?

[Laserpoint and Sign Blazer installation?]

this thread helped me out. Uscutter. why don't someone write a nice setup instruction on the unit? I don't see it as a hard task. If you want to push these units, at least have some proper instructions to get these things running with pictures! :why:

[Drivers to get it to work w/ flexi?]

My computer isn't reconizing my laserpoint 24, i installed the usb drivers it came with. What's my next step. I have signblazer installed and flexi as well.