Well, after reading through this thread, I thought my problems were over. I had been experiencing this same issue and was wasting vinyl by the yards. After trying the reset trick I got a couple of things to print in a row, which hadn't happened yet. But then it stopped again the third time through, even after resetting several times. And now I have a cut that I can't get to work for anything. I've tried at least ten times and each time it gets just a few letters into it and then I can see that blazer stops sending to the cutter. The tracing of the cut stops exactly where the cutting will stop and the blue progress bar that says it's sending to cutter just freezes. I've tried tweaking baud rates, I've changed the port, I've changed the cable, I've rebooted, and I can't cut this. I'm very frustrated right now and just burned through several yards of good vinyl trying to get this to cut. :'(
I can't believe more people aren't experiencing this issue. For the record, this is a brand new Toshiba laptop running Windows XP. Anybody have any suggestions?