Hi - complete novice here! having recently 'inherited' this Graphtec cutting plotter, and I am starting from scratch learning via tutorials and videos and now joining forums!!
attached photo shows the X + Y axis and you may be able to see the cut line. initially this cut line was 5mm out and I have located within the arms settings how to adjust, BUT it will only allow for a 3mm tolerance (so now shows that it is 2mm out)
Is there something else that I have not considered or is this the only way of aligning these axis to the correct points?
Graphtec CE6000-40 Sensor Offset Adj
in GraphTec Cutting Plotter Discussion
Posted
Hi - complete novice here! having recently 'inherited' this Graphtec cutting plotter, and I am starting from scratch learning via tutorials and videos and now joining forums!!
attached photo shows the X + Y axis and you may be able to see the cut line. initially this cut line was 5mm out and I have located within the arms settings how to adjust, BUT it will only allow for a 3mm tolerance (so now shows that it is 2mm out)
Is there something else that I have not considered or is this the only way of aligning these axis to the correct points?
any suggestions welcome