precisionarchery

When scrolling through the options using the set button on my Titan 3, I see that there is a Tool X adjustment and an Offset Y adjustment selection. What are these used for? I do all of my adjusting through SCUT Pro. Is this for making finer adjustments directly through the machine?

Will give that a try and see what happens.

May be so, I'm not entirely sure. They are only displayed as Tool X -5.49 and Offset Y 23.04. If I change the values, and then reset the machine, the numbers go back to the stated value. Was kind of hoping these were for fine adjustments for cutting. I run one piece carbide green star blades that cut way better than the typical Roland cemented blades, but find that I need to adjust the offset in my software a little. I cut a lot of really fine intricate designs and have issues with ears and lifting and was thinking that these settings could be adjusted to stop that from happening.