Fireflynj

Optimize cutting order is already on and set to 10" I will experiment with some lower numbers. only problem I had was something shifted along the way and some cuts did not line up. but, it might of been because I did not have pinch rollers tight enough. I will be paying more attention. Thanks

LXi Apprentice (Flexi light 8.6) I also have CorelDraw x5 but have not used it to cut, I only used it for editing. I don't think its Tile, it cuts part of a letter not finishing it, goes cut some other letter and comes back to finish that letter later. Thank you

I don't know if there is such thing or what to call it. is it normal that the cutter cuts part of letter then feeds the vinyl to other end to cut some letters there then goes back to finish that letter? it seems to be a waste time cutting things all over the place randomly instead of staying on one side of roll and work its way up. there a way to make cutter cut all letters from the beginning of roll and work its way up? Thanks

But how close does it cut to the leading and trailing edge? left/right is typically .25" but I also would like to know about how much waste is at the ends. Thanks