Ric

I have not found a good discription or diagram of how best to ground the cutter. Anyone have a link or diagram to share? Thanks in advance.

I have a dumb question about how the licencing works for SignBlazer. Is there any problem installing it one one computer now and reinstalling it in a couple months when I build a new box? I have no need for it to be on multiple computers, but it could be interpreted that way when I reinstall on new hardware.

I had this same problem and resolved it by removing the fill from the objects. It appeared to me that the cutter was going around once for the fill and a second time for the outline. removing either resolved the problem.

Can someone explain this issue in a little more depth? Is the offset something that needs to be accomidated in the design or simple through hardward settings? I assume that the offset is in relation to the blade and it's point not being at the true center of the rod is is at the end of? Thanks in advance for the information.

Is it possible to get more detailed instructions of what you mean? Frankly, I don't want to mess you the cutter before I get any use out of it.

I just got my MH721 and noticed that the white band that acts as the cutting surface is not stuck down well and is bubbled up in several locations. I have tried pressing is back down as you would tape or vinyl, but it comes back up almost instantly. It has not impeded my early testing of the system using the pen attachment, but seems odd. Is this a problem and is the a reasonable fix?

I just got my MH721 in this morning and started setting everything up. Unfortunately, I can not find information anywhere as to which of the two spots in the snowman shaped holder on the caridge to put the blade. I'm sure the answer is somewhere, but I have not found it. Thanks in advance.