KMCreations
-
Content Count
5 -
Joined
-
Last visited
Posts posted by KMCreations
-
-
OK I will try that. It completes the cut the 2nd time and a time again after that. But usually every new cut I make it does this the first time, lately the 2nd time too.
-
Hi Everyone,
Lately my MH721 vinyl cutter has been starting it's cut and then 5 - 8 seconds into the cut it stops and I have to start the cut all over again - it's wasting a lot of my vinyl. Especially on big pieces when it goes half way down the vinyl and stops. What is going on?
-
Hi Everyone,
I was wondering if it was possible or not recommended to cut with 2 programs. I was previously using Sign Blazer Elements, but bought a new cutter and now have VinylMaster Cut. I am not familiar with VinylMaster Cut and have all of my other files on SBE. Is there a way to cut from both programs without messing anything up?
-
Hi Everyone! I just received my new USCUTTER MH721-MK2 and it came with the VinylMaster Cut program. I was previously using Sign Blazer and I am very familiar with that program and have all of my designs on that program. I got my vinyl cutter working with the new program but was wondering if there was a way to set up my Sign Blazer and my VinylMaster Cut program to use the same cutter without messing anything up!
Thanks for your time!
Vinyl Cutter Stopping Mid Cut
in USCutter Refine Cutting Plotter Discussion
Posted
Yeah, I always push RESET otherwise it rolls my vinyl out the back of the cutter.