I dont know what i am doing wrong

[angel48e 0]

My pcut ctn630 just doesnt seem to be cutting all the way thru.

I adjusted the blade

I am not using a laptop

I am not using the usb, I am using the serial port

I checked the cutting strip it ok

I need help my machine is new im not sure if there are some settings or something i am missing

It cuts ok on straight runs but when it turns or does circles it doesnt seem to be cutting all the way thru

[kenimes 42]

Set the pressure to 120-150, but do not lower it below 120. If it cuts too deep when set at this pressure, the blade is sticking too far out.

[angel48e 0]

On a regular machine cutting 4year vinyl what should the setting be

[kenimes 42]

Try a pressure of 120-150

[angel48e 0]

I tried it all

the settings for the press

speed, the blade adjustment and i just cant seem to get it to work

What do i do next?

[kenimes 42]

I would try increasing the pressure in increments of 10, starting at 120, then adjust the blade depth accordingly until you get a good cut. It takes alittle trial and error is all, before you get it dialed in.

[rgaskins 0]

Not sure if you tried this yet, but you may want to read this post...

http://forum.uscutter.com/index.php/topic,3362.0.html

There is some GOOD info there about blade setup....

Rick