brandnewguy 0 Posted September 18, 2014 The vinyl crumples when it gets within 3 inches of the end of the vinyl when cutting, and i believe it has something to do with the slight bubbling occuring feeding mid cut. It doesn't happen when selecting the origin point though. Any ideas? p.s Is the LaserPoint 2 supposed to come with more than one silver crossbar for holding the vinyl? I imagine it would sit on two and unrolling wouldn't be a problem. I've just had my one going thru the vinyl rolls and it unrolls unless i have something stopping it. Thanks Share this post Link to post Share on other sites
jaybyrd 3,770 Posted September 18, 2014 Machine should NEVER have to pull vinyl off the roll. It should be prefed before cutting to avoid that and yeah there should be 2 rollers for the roll to sit on. 2 Share this post Link to post Share on other sites
101LEDs 100 Posted September 18, 2014 Also Check the tension on the lockdowns that sit over the pinch rollers. Mine were all the way tight out of the box, way too much. I had to loosen them by more than 50%. Yes you should have 2 rollers, call USC and let them know one is missing 1 Share this post Link to post Share on other sites
jaybyrd 3,770 Posted September 18, 2014 Too much blade exposed can also cause the vinyl to bunch. 2 Share this post Link to post Share on other sites
brandnewguy 0 Posted September 19, 2014 Thanks folks, tons of help. Hopefully I'll be receiving that bar very soon! Share this post Link to post Share on other sites