rudedog 10 Posted November 21, 2013 Not sure if this is an offset issue or something else. I'm using a Copam CP-2500 w/ a 45 degree clear cut blade via SCALP on a Mac Say I cut a square, the sides are straight and the corners are 90 degrees. However where ever the blade starts then ends there is a little piece of vinyl not cut that I have to kind of pull apart when weeding. Is there another setting I should be looking for in SCALP or is this an offset issue? I have my blade, pressure and speed set correctly that I can cut very very tiny text but it's hard to weed because of these unfinished cuts (not sure what to call them) I did some amazing cuts last night but had some problems weeding the smaller areas because of this issue. Thanks in advance -Jim Share this post Link to post Share on other sites
darcshadow 1,626 Posted November 21, 2013 You want to look for an overcut option. Not sure if SCALP has that or not. Share this post Link to post Share on other sites
rudedog 10 Posted November 21, 2013 I think I saw that. I'll give it a try Thanks Share this post Link to post Share on other sites