cutting multiple jobs, and cutting over first job issue...

[muibubbles 2]

I have the mh871, and cutting with SBE. Now im not sure if its a cutter or software issue....

my problem is when the cut is done it leaves spacing to start a new job, perfect! yet when i send another cut, it reverses the vinyl and starts cutting on my previous image......

right now ive been turning my cutter off if im sending multiple jobs after one another so they dont overlap. i suppose i could also pull the vinyl out more between jobs..

Ps i just thought of this, does the cutter "think" im going to pull the vinyl out and cut it so it compensates for that and re adjusts it? is that what the "grooves" across the cutter are for? references for distance?

[arty-rc 719]

You have to set the new origion point before every new cut.

[muibubbles 2]

what do you mean by that? (sorry im a newbie)

is it like a setting? bcause even if i pull the paper forward it reverses the paper and then starts cutting.

[MZ SKEETER 4,709]

what do you mean by that? (sorry im a newbie)

is it like a setting? bcause even if i pull the paper forward it reverses the paper and then starts cutting.

origin button. is on your vinyl cutter. It tells your vinyl cutter where to start. Read your user manual.