inksane 2 Posted April 10, 2012 My power supply just crapped out on me today so i ordered a replacement should be here in a few days, i just wanted to know if anyone could tell me how to replace it. i have never opened the unit up. Thanks, Kyle Share this post Link to post Share on other sites
Dr12volt1338 116 Posted April 10, 2012 I am sure its very simple once you get the main cover off should be pretty self explanatory to remove once you have it tore down to that point. It may even come with some directions. Make sure you are static free as you are touching the circuit boards and what not inside the machine. Share this post Link to post Share on other sites
mb20music 760 Posted April 10, 2012 I think I read somewhere that in order to get to the power supply, you turn the cutter on its side and remove the 8 screws on the bottom, and the power supply should be visible once you remove the panel. Then you should be able to figure out how to remove and replace the power supply once you see it. Share this post Link to post Share on other sites
perry 13654 1 Posted April 27, 2012 When removing the panel only take out the 8 screws on the sides of the bottom, the screws on the very bottom remove components and they will fall. ( you can imagine figured this out) Share this post Link to post Share on other sites