smallTIMER 21 Posted May 2, 2011 Hey guys, Has anyone created some sort of lighting that they have set up or built that is attached to their machine? I want to go beyond the typical desk lamp or clip on lighting and get some type of LED strip and incorporate it to the machine and I am trying to look for some ideas or products that you have used Thanks Share this post Link to post Share on other sites
livinloudgraphics 39 Posted July 13, 2011 If i am understanding correctly you are trying to put a light on your cutter so you can see if its making good cuts or not? Share this post Link to post Share on other sites
smallTIMER 21 Posted July 14, 2011 Not just to see if it is making good cuts, but yes I am trying to put a light on the cutter Share this post Link to post Share on other sites
livinloudgraphics 39 Posted July 14, 2011 I use the led strips from my local Autozone or advance auto you can get them on ebay too they are white and have there own battery just wire up a toggle switch so you can cut on and off Share this post Link to post Share on other sites
cd.edwards 1 Posted August 28, 2011 You mean like this? The Creation Power Supply put out 12volt. I took a LED strip light and installed it in the lid of the cutter, running some wire from the power supply to the strip. Share this post Link to post Share on other sites
Jay2703 704 Posted August 29, 2011 You mean like this? The Creation Power Supply put out 12volt. I took a LED strip light and installed it in the lid of the cutter, running some wire from the power supply to the strip. That is sweet. Share this post Link to post Share on other sites