rotary tool

[cincy128 0]

Just got my new PCut. The knife holder I have isn't the same as the manual shows. Mine is a black 2 piece unit with a small shaft sticking out of the top. I also have a black 2 piece pin holder.

Are these the correct tools?

thanks,

Scott

[cincy128 0]

Ran a test cut. Looks like this tool is OK.

Read a few of the other posts having the same question. Guess I'm in good shape.

[kenimes 42]

Yes, the included blade holder is a Roland blade holder, and the ones in the manual are Creation blade holders. They look different, yet function in similar ways. The little silver push rod coming out one end is to extract the blades when they get dull. The blade goes in the other end with the blade part sticking out. With the screw end completely tight, the blade is sticking out way too far, so twist that end until the blade is barely sticking out. Now put it in the back position of the carriage arm.