orbitgrfx 0 Posted May 11, 2010 Hello everyone! I'm reading great posts about the clarity of CleanCut blades. Which supplier do you guys get them from? The MH series uses Roland type blades, I'm sure they are interchangable, aren't they? Share this post Link to post Share on other sites
hockeygirl 30 Posted May 11, 2010 http://www.cleancutblade.com/Home.htm Give them a call and they'll get you set up with the right blade. Share this post Link to post Share on other sites
bamafan2277 50 Posted May 11, 2010 Hockeygirl is right. Give them a call!! Great place to deal with and Great blades!!! I am going to be ordering me a couple more to keep as backup and one for reflective. Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted May 11, 2010 Ross is great to deal with Jeff - get another holder for the reflective blade (use a used blade for this one) then you don't have to reset the depth etc when changing blades! Share this post Link to post Share on other sites
orbitgrfx 0 Posted May 11, 2010 Great!!! Thanks for the super fast response. This is why I've come to love this forum! Share this post Link to post Share on other sites
warrior35 2 Posted May 12, 2010 Ross is great to deal with Jeff - get another holder for the reflective blade (use a used blade for this one) then you don't have to reset the depth etc when changing blades! Dakota- How much do you change the depth of the blade for the reflective? I have only cut reflective one time and I just adjusted the pressure of the cutter and it worked alright. I wasn't really pleased with how it cut but I wasn't sure if I had everything set exactly right. It was a learning experience. Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted May 12, 2010 That is hard to quantify but a little deeper and with the second blade holder makes it so I don't reset the depth again Share this post Link to post Share on other sites