Cutting_Edge 6 Posted January 8, 2010 Have tried both inkscape and Corel Trace......comes out looking horrible.... Is there any way of vectorizing this? TIA Margaret Share this post Link to post Share on other sites
JoeDirt 5 Posted January 8, 2010 How are you going to cut the fade anyways? Just have five star print it for you very nice pricing and fast delivery. Share this post Link to post Share on other sites
Cutting_Edge 6 Posted January 8, 2010 The quality of this for printing is pretty poor.....I have printed it, but didn't look as good as what I wanted....I changed the dpi on it and tried to clean it as much as I could, but still doesn't "pop" like I would like it to...that's why I thought it might be better if it was vectorized.... Asked the customer for better quality of this, but of course, he has nothing and cannot remember who created it in the first place. Margaret Share this post Link to post Share on other sites
Guest fivestar Posted January 8, 2010 Margaret you need manually trace it then use a gradient fill on the "brush stroke". Share this post Link to post Share on other sites
Cutting_Edge 6 Posted January 8, 2010 Thanks, I will try it...but figure I will probably land it in the customer's hand...he expects perfection from crap and doesn't want to pay to have the artwork done on this. Margaret Share this post Link to post Share on other sites
JoeDirt 5 Posted January 8, 2010 well I tried in illy but same results, then I put it in flexi to try and get the paint to go up on the brush and no luck either. but here it is maybe its a start?? LPG.eps LPG.eps Share this post Link to post Share on other sites
Cutting_Edge 6 Posted January 8, 2010 Thanks, I will give it a shot and see what I can do w/ it. Margaret Share this post Link to post Share on other sites
Guest fivestar Posted January 8, 2010 Here's a start on your brush, needs a little work. Took about 3 minutes. Brush.eps Brush.eps Share this post Link to post Share on other sites
JoeDirt 5 Posted January 8, 2010 hey I only took 2 1/2 Share this post Link to post Share on other sites
rjfox 0 Posted January 8, 2010 Here is one. Logo2.eps Logo2.eps Share this post Link to post Share on other sites
Cutting_Edge 6 Posted January 19, 2010 Thanks everyone for your help......I finally got it to where it looked pretty good for the printing. I appreciate everyones help. Margaret Cutting Edge Share this post Link to post Share on other sites