luckytots 0 Posted November 14, 2007 Is the LaserPoint/PCUT able to cut twill or other fabric? If so, is this covered by the warranty, and what blades/downforce is appropriate. Specifically, I am looking at using the "Poly-TWILL" material from imprintables.com: http://imprintables.com/index.cfm/fuseAction/dspCatalogCategory/catID/29/index.html Thanks, Stephen... Share this post Link to post Share on other sites
jayben03 0 Posted November 23, 2007 I have cut pressure sensitive poly twill before from stalls and when I cut the twill I slowed my cutter all the way down to the slowest speed and then I think that the down pressure was about 200 but it may be different from your plotter.The best thing to to to find the right down force would be to try and cut the test of a square inside a square on a scrap piece. And about the warranty I cant help you out with that but I do know that it should cut poly twill as long as it has the clear tape on the back. Let me know how this works for you and post a photo of what you have cut if you would like. Jay Share this post Link to post Share on other sites
luckytots 0 Posted December 4, 2007 I ordered a sample of Poly-TWILL from imprintables.com, and the Laserpoint was able to cut it just fine. I am not saying that these settings are optimal, but this is what I used to cut the Twill: Blade: Roland 60 degree blade Downforce: 60 Cutspeed: 30 Software: DirectDrive (Module for CorelDRAW) Stephen... Share this post Link to post Share on other sites