signco 0 Posted October 15, 2007 Hi, I am wondering if I can cut directly from corel to my mh721..... ?? Any advice would be greatly appreciated..... i really don't want to use signcut if I don't have to.... thanks Share this post Link to post Share on other sites
kenimes 42 Posted October 15, 2007 I guess you can with Corel X3, not sure about the other versions though..... US Cutter Refine MH721 Setup.doc US Cutter Refine MH721 Setup.doc Share this post Link to post Share on other sites
stormy 5 Posted October 16, 2007 I have Corel X3 and all I do is go to the application launcher and it sends the image to signcut. Takes all of about 3 seconds then I press cut. Not all that hard. Share this post Link to post Share on other sites
gg 1 Posted October 16, 2007 I do the same, I have experienced gliches sometimes w/the eps that is created for S/C thru the "Rocket Launcher" in Corel. So I have started exporting my files as an .ai version 4 and have had no problems w/ th ai file, take a min. longer but the rusults have been worth it. if it's a small quick cut, I "launch the rocket" Share this post Link to post Share on other sites