russdabuss 1 Posted April 28, 2009 Hello, I have had pretty good luck with this software and my MH721 cutter. I also use inkscape and like it. Last nite i tried to cut a long wall vinyl. 69 inches long. It would not cut in just 1 piece it kept making it into 2 cuts (the last 8" or so). I tried to figure it out and could not. I changed my layout size which I have done before but this still did not work. any ideas. It is only 6" tall but 69" long. thanks Share this post Link to post Share on other sites
firemalt 10 Posted May 1, 2009 Did you change the material length in the cutter setup on SBE? One you have the deisgn you want, click on the "cutter", and then click on "setup"... there you need to also change the length of material/. Share this post Link to post Share on other sites
russdabuss 1 Posted May 2, 2009 FireMalt, THANKS!!! That works. Not sure why I did not see that!! I Appreciate it MUCH Russ Share this post Link to post Share on other sites