Hello fellas
I recently did some strips for a car for covering some old paint damage using Creation PCUT CT0630
I noticed that while cutting the strips the cutter knife didn't finish at the same place thus giving a tail on one side( see attached).
Any ideas wherein I am going wrong please???
These strips are 11 mm wide and 1800 mm long.
Also I noticed that the sheet starts to deviate when cutting the length of the strip, I mean the width is not uniform as if the sheet is slipping out of the rollers
My operated settings are as follows:
Speed 50
Press: 118
Offset:0.02
Regards
C.S.Kainth