Search the Community
Showing results for tags 'Complaints and suggestions'.
Found 1 result
Hello fellas I recently did some strips for a car for covering some old paint damage using Creation PCUT CT0630 I noticed that while cutting the strips the cutter knife didn't finish at the same place thus giving a tail on one side( see attached). Any ideas wherein I am going wrong please??? These strips are 11 mm wide and 1800 mm long. Also I noticed that the sheet starts to deviate when cutting the length of the strip, I mean the width is not uniform as if the sheet is slipping out of the rollers My operated settings are as follows: Speed 50 Press: 118 Offset:0.02 Regards C.S.Kainth