marcmcm

Depends on what you're trying to do. If you're trying to drive traffic to your site, proper selection of keywords and using Adwords can definitely help. If you're trying to actually make sales, you may want to look at your product. I tried Google Adwords for a month, spent $100 and my site traffic increased 15%. Not bad as I'm only trying to drive traffic and not make sales.

If its just temporary try flyingcart.com. It's free for less than 5 items.

Well I bought a parallel card and still no dice.

That would be great if my Copam had a USB connection on it. All I have is parallel and serial.

Thats probably some very good advice...

Recently had to switch from a Parallel connection to a Serial to USB connection. Installed the USB 2.0 driver and I get nothing. Checked all the port settings in the device manager and in Signcut x2. I even tried downloading signblazer and I can't get the cutter to move at all. Any help would be greatly appreciated!

I have the old Serial to USB. I tried the old and new drivers, neither one is making it cut.

I had to get a new mtherboard and the new one doesn't have an LPT1 port. The serial port i too close to the video port so the serial won't fit. I'm left with USB and I installed the USB 2.0 driver and it still doesn't cut. Which port do I tell it to use in Signcut? I tried Summa USB and Gamma USB and neither do anything. The cutter worked great when hooked up LPT1, now it won't do anything. Any ideas?

On the toolbar is the cutter set at 90 degrees or 0 degrees?