King of Teez

What I usually do is bring the heat to 350 and the time down to 15 secs... then I slowly lift the transfer while warm. Then I place a teflon sheet on top of the print and apply heat for another 10 secs... this way you will eliminate the yellow...

I also just got my Co Pam today. Have not cut anything yet... But it has a very solid build. I am excited!

THANKS!!!!!!!!!!!!!!!!!!!!!!

Livonia borders me... I am in westland. I will have to check out wensco. Thanks Joe!

Thanks a lot Tory! This is great info. Sterling Heights is about 30 mins away. Fedex just dropped off my cutter ( I thought it was coming tomorrow ) so I will run out to Sterling Heights today! Thanks again!

Which company do you use? Who has the best pricing?

I am new to this forum, new to cutters in general. I just purchased a CP-2500 that should arrive tomorrow. I am looking for a decent vinyl supplier located near southeast michigan or someone who ships quick and cheap to my area. If you can guide me in the right direction I would greatly appreciate it. -Mike