oldboyoh

How do i do that?

UPDATE: I got it to not crash by restarting with fresh driver install. Now its not responding though when I initiate a cut

When i try a fresh driver install it says "Windows found driver software for your device but encounterd an error while attempting to install it. one of the installers for this device cannot preform the installation at this time."

Thanks, a fresh install for the drivers or SB? I usually leave it in same port too it just wasnt working for some reason @_@

Ok so I didn't use my cutter for a month or two and now I cant seem to get it up and running again. Every time I plug it in it says it failed to install the drivers, I didn't notice this at first so I went to cut my vector out in SB and when I hit "printer settings or Home position" I get the warning that there's been an un-recoverable error and it crashes.So I figured it must be a driver error.... I only can find the cutter listed under "USB printer support" If i remember correctly it used to directly list the printer and connected fine. I've also tried manually installing the drivers and the install usually fails. The USB printer support might have gotten installed when i plugged in a regular printer? I've tried multiple ports and have had 0 luck.