freebird1963 11 Posted April 25, 2007 probabaly silly but didn't see it in the online or in the paper manual. When loading the vinly do you put it all the way to the right (looking from the front) against the unit ? seems like you lose 3 inches or so of vinly. or go far left ? And when using vinly smaller than the plotter were is the best place to load it at ? same with paper ? and what paper can you use to pen plot on with ? Thanks Newbie Mark Share this post Link to post Share on other sites
Guest fivestar Posted April 25, 2007 I put mine right at 3 inches from right, standing in front of machine. I don't like losing any Also make sure it is lined up perfectly or it will "walk" to one side or the other. I always run the "show me" in flexi to make sure the vinyl stays under the knife. If you are using SignCut I'm sure they have a similar feature. Share this post Link to post Share on other sites
