charlie_b CFXPaintworks 1 Posted July 9, 2008 My name is Charlie Barnes and new to this scene, but not new to cutters. Currently, i have a Roland SX 15 and has done very well for me. I am an RC Car painter and have used my SX15 to cut hundreds of paintmasks out of it. Although, after over 9 years of using the cutter, i feel i have out grown it and is ready to upgrade to a 24" cutter. I have had my eyes on a Roland GX 24 until one of my Moderators of my forum directed me here, so here i am. I am interested in the UScutter Laserpoint 24, but am not fully convinced it may be the best for me. I plan on doing signs as well as tshirts with it on top of going in production for my precut rc masks to sell. If any of you have any suggestions/recommendations, it would be greatly appreciated. BTW, i use Adobe Illustrator to design my masks. I assuming signcut is the program to use to cut my AI files? Thankyou again in advanced. Charlie B cfxpaintworks.com Share this post Link to post Share on other sites
Guest crshirts Posted July 9, 2008 Welcome and have fun Carl Share this post Link to post Share on other sites
nonabelle 5 Posted July 9, 2008 welcome to the forum! Share this post Link to post Share on other sites
Guest kenya Posted July 9, 2008 Welcome to the gang! Share this post Link to post Share on other sites
charlie_b CFXPaintworks 1 Posted July 10, 2008 Thanx guys..looking forward to learning here! Share this post Link to post Share on other sites
polarkiss 1 Posted July 10, 2008 welcome! always good to see a fresh face Share this post Link to post Share on other sites
HawgDawg 0 Posted July 11, 2008 Welcome You got talent Dawg Share this post Link to post Share on other sites
charlie_b CFXPaintworks 1 Posted July 11, 2008 Thanx Dawg and Wayne! Glad to be here. Share this post Link to post Share on other sites
