Exnuns 2 Posted September 13, 2016 Somebody please help me, I have searched every corner of the internet with no success... Let me start off by saying, I received my Laserpoint 2 today.. It came with no instructions, it didn't come with enough screws, the product key for sign cut was NOT valid, and now I can't get my mac to recognize the plotter. I've installed the FTDI Usb Driver, Got a TRIAL of signcut, and done everything I can think of, but cannot figure it out. It's connected via the usb cord. SOMEBODY please read this and HELP. Share this post Link to post Share on other sites