cegglestn 0 Posted April 29, 2008 I need the signwave above the letters to be clean because its going on a large banner. Can anyone clean it up so it cuts clean on SB? thanks chris FClogo.eps FClogo.eps Share this post Link to post Share on other sites
bk2design 1 Posted April 29, 2008 How big is the final image? Share this post Link to post Share on other sites
cegglestn 0 Posted April 29, 2008 the sine wave is going to be around 15"H by proportional thanks chris Share this post Link to post Share on other sites
bk2design 1 Posted April 30, 2008 Well, I thought I was going to have time to help ya but I'm running out of time tonight and I'm going out of town tomorrow. I did get a chance to look at it though. I increased the height to 15" on the sine wave and it didn't look too bad. A few tweaks here and there and then removing the white outline. If no one else can help you I will be back sunday. Share this post Link to post Share on other sites
dbtoutfit 5 Posted April 30, 2008 See if this will work. Eric Share this post Link to post Share on other sites
malachiind 0 Posted April 30, 2008 Here is what I came up with. Looks like it will cut clean and nice. good luck fccustoms.eps fccustoms.eps Share this post Link to post Share on other sites
cegglestn 0 Posted April 30, 2008 thanks, should work chris Share this post Link to post Share on other sites
Guest Terry Posted April 30, 2008 Hope it works for you, I started on it but got beat to it. I saw node dots in it I was removing, but then thought it would be quicker to vector the wave over again. nice work. Share this post Link to post Share on other sites
dbtoutfit 5 Posted May 1, 2008 Looked to me the wave had ben done with the "line tool" and then offset. Real Pain. I am sending him my invoice right now 56 thoooowwwsand Dolla's! Eric Share this post Link to post Share on other sites