vicentillo29 0 Posted November 24, 2015 hey guys i was cutting a 24" vinyl and noticed some straigth letters not closing and when finish cutting the vinyl was off about half inch from the ruler line is there any easy way to put tension to the rollers i dont know if i have them with the right tension Share this post Link to post Share on other sites
KYSIGN 233 Posted November 24, 2015 You can adjust the tension using the screws on the back of your pinch rollers if needed. First check that your vinyl and pinch rollers are positioned over the textured/knurled sections of your grit roller bar. 2 Share this post Link to post Share on other sites
