Engraving Adapter

[smoovlatino 0]

Does anyone know where to get an engraving adapter for the 721?

[thredz 1]

I think the roland adapter fits.But I'm not positive on that.

[smoovlatino 0]

Do you know where it can be purchased?

[thredz 1]

I've seen them on ebay.But I couldn't tell you who carries them.I think they cost around $90.00.

[marcuso 15]

We purchased a kit (same as eBay).  I do not really like the company (I have heard that they use really shady competitive tactics - worst than Signwarehouse), but if you really need a kit, it will work with the Refine. It primarily consists of:

Bladeholder with diamond tip (I am sure this would be pretty easy to make)

A DVD instructional video (fairly well done)

Carrier material (basically just plastic sheets)

What they don't tell you is that you are supposed to construct an infeed and outfeed table for the unit (which will take some time).  The kit will work fine with the Refine.  With the Copam, the bladeholder is the wrong size (but can be adapted).  If anyone wants to do a full review of the kit, I would be glad to sell you ours for $60.

[thredz 1]

I'll take it and review.Do you need me to send you a check first?