goldnail 0 Posted October 18, 2015 Hi, I am new to vinyl cutter. I am using Laserpoint II and Surecut a lot pro. I found the cut out decal is a little bit smaller than the design. For example, the design is 12" but the cut out decal is only 11.75". Is it normal? If not, where the problem is? Software or hardware? And how to correct the size please! Share this post Link to post Share on other sites
KYSIGN 233 Posted October 18, 2015 http://forum.uscutter.com/index.php?/topic/48656-cutter-cutting-decals-slightly-too-large/ Hopefully this will help. It's the opposite of your problem but the same concept. Share this post Link to post Share on other sites
goldnail 0 Posted October 18, 2015 Thanks again! I got the answer and have just made it. Share this post Link to post Share on other sites