bethj95 0 Posted April 21, 2008 so I have some images that I got on a disk that are eps but when I go to print the cutter cuts them two times (so going over the same lines twice) and so the vinyl gets pulled up and the sticker is basically ruined and I am not sure how to correct this problem I use win pc and corel any ideas??? Thanks :- Share this post Link to post Share on other sites
mark-s 1,126 Posted April 21, 2008 Need to take the first layer out before cutting. mark-s Share this post Link to post Share on other sites
bethj95 0 Posted April 21, 2008 I have done that......well I mean I have just drug off the first layer so it jsut looks like an ouline but hen I go to cut it still cuts more then one layer..... Share this post Link to post Share on other sites
firemalt 10 Posted April 21, 2008 Either there's another layer to remove, or you could try to weld the image in SB. If you're able to weld the image, that should fix your problems... I think. Share this post Link to post Share on other sites
mark-s 1,126 Posted April 21, 2008 Sometimes there are 3 and 4 layers depending on how it was built. Keep deleting layers until you get to the 1st one. Most layering is due to coloring. mark-s Share this post Link to post Share on other sites