Cutting problems

[wrongway66 0]

Refine mh721

xp home

signcut 2x

com1 (Lpt wouldn't work)

The cutter works great, right up to the point that it finishes the cuts. Then, it drags the pen/cutter acrossed the finished project and goes the whole way to the end of the carraige and there is a stripping noise. Then it goes the whole way back to the start edge and does the same thing. The weeding lines are all, except one, cut along with the bottom line. Please give me a little advise! Thanks!

[marcuso 15]

I am not sure what the problem is.  Check the subversion of Signcut and be sure that it is at least 2.16.  Also, check you flow control settings and set it to Hardware.  If that doesn't work, I would also post this question in the under the "Signcut" forum and see what Kjell has to say.  Be sure to keep us updated on the results.