BBBenson 0 Posted September 14, 2012 posted a couple days ago about a bad signcut test cut...connected a serial to serial to a desktop computer..tried it out and still the same result. I was A LOT closer this time but still didn't cut correctly. This is my second MH871. I was hoping to get a couple more jobs done and make enough money to upgrade, but can't figure out why both cutters are having this problem...I've tried switching blade offsets. If anyone has suggestions, feel free to shoot away. I feel like I've tried everything! I've also tried both SignCut and SignBlazer, both have the same end effect. Share this post Link to post Share on other sites
lizzylou 11 Posted September 14, 2012 What driver etc are you using to set up? Sounds like your set up. Have you followed everything here? http://start.uscutter.com/ Share this post Link to post Share on other sites
BBBenson 0 Posted September 14, 2012 hmmmm, I swear my Buad was supposed to be 9600...but that one says otherwise, anybody have a suggestion to just delete everything so i can start all over? Ive tried deleting the device before but it just pops back up once i plug it back in.. Share this post Link to post Share on other sites