scoobybry 0 Posted June 28, 2012 Hi guys i am using a ct630 ( USB port only on the cutter ) and a laptop with windows 7. I have assigned ll the ports ect on the comp and in signblazer. However sometimes the image says sending and the cutter does not respond, but then others it will work fine. When the cutter is off it still says its sending the image . Also the cutter head when cutting sometimes stutters ( Jerky ) but still cuts the image ok. Is this down to the usb to usb lead? Would i be better with a desktop set up and use a serial port to the usb port on the cutter? Hope this makes sense. Thanks Share this post Link to post Share on other sites
mb20music 760 Posted June 28, 2012 Yes better to use serial port on the lower end cutters, a serial adapter might help. Or possibly your USB cable is too long, you can try changing it to a shorter cable. Share this post Link to post Share on other sites
scoobybry 0 Posted June 28, 2012 thanks for the reply i have changed the cable. So if i set up a desktop and the get a serial that has the usb end on for the cutter this should work better ? Share this post Link to post Share on other sites
mb20music 760 Posted June 28, 2012 You may need one of these, I can't guarantee it of course but they have worked for some people. http://www.uscutter....DAPTER-KSPADAPT Share this post Link to post Share on other sites
mb20music 760 Posted June 28, 2012 wait a minute that isn't what you need, nevermind. Share this post Link to post Share on other sites
mb20music 760 Posted June 28, 2012 So your Pcut does not have a serial or parallell port? only USB is that correct? Is it a newer Pcut? Share this post Link to post Share on other sites
scoobybry 0 Posted June 28, 2012 hi it just has the usb port Share this post Link to post Share on other sites