Threadbare 0 Posted May 1, 2012 Not every time, but on certain images, the cutter will go to outline the image as it always does, and then instead of making a complete box around it, it cuts a diagonal image through the center of the image. I'm using Inkscape to convert jpgs to eps, then sending to Sign Cut. Using my mac and Creation PCUT CT630 Thanks for any help. I've already searched the forums. Share this post Link to post Share on other sites
locknload1 17 Posted May 1, 2012 Your computer had a port fart. Mine used to do that sometimes when it was on com2, I moved it over to com3 about two years ago and it never happened again. Static build up can cause it too so it's a good idea to have a box of dryer sheets handy to stuff one into the roll on cloudy/humid days. These machines get a bad rep unfortunatly due to some users lack of mechanical/computer skills however once you have it all dialed in and spend about $40 on a better blade holder and blades your already $800-$1,000 ahead. Mine has run hundreds of yards of vinyl over the past 4 years with zero issues or breakdowns. Share this post Link to post Share on other sites
Threadbare 0 Posted May 2, 2012 Hmm, thanks I'll try a few things. Share this post Link to post Share on other sites