MH-871 skipping/tapping wheb cutting curves.

[joey1320 1]

I had posted another similar question regarding my brand-new MH-871 cutting curves erratically and that turned out to be a font issue as opposed to a cutter issue. Well after changing fonts and messing around with the settings, I'm now getting a better finish on my curves but it is skipping/tapping when making them.

Anytime I cut a "P" or an "O", which are two of the letters on a friends logo, while cutting the curves, the blade start tapping against the vinyl which causes a dotted cut, which then looks bad after weeding.

I tried adjusting the blade, the pressure, the speed and I tried a small amount of oil on the bladeholder for proper lubrication. I'm using CADCUT's Super Film which is insanely thin, if that matters.

I haven't tried using the pen plotter to see if it does it, so I'll try that tonite. But in the meantime, any ideas as to what it could be?

Thanks for the support.

Joey