BBOwen 0 Posted February 3, 2008 I ran this file through Vectormagic. When I imported it into SignBLazer it didn't show all the lines. What is wrong with it? Gamer_copy.eps Gamer_copy.eps Share this post Link to post Share on other sites
Guest sciondrgn Posted February 3, 2008 Post the original so we can see what it is supposed to look like.. I can open in Signblazer and Flexi and I get this Share this post Link to post Share on other sites
BBOwen 0 Posted February 3, 2008 This the PNG but it is the same. Share this post Link to post Share on other sites
Guest sciondrgn Posted February 3, 2008 Ok gotcha, I see what you were saying Now.. Load the image in Signblazer and select it, Click on the Arrange Menu then go down to Weld and do the Total Weld option, Now go to your cutter and it should cut the whole image. Share this post Link to post Share on other sites
BBOwen 0 Posted February 3, 2008 That was it, Thank you so much! :you rock: I figured it was something simple like that, I just couldn't get it. :bang: Share this post Link to post Share on other sites