smithmotorsports99 1 Posted March 29, 2011 Hi, I was sent this logo to redo for a racer in the area. Any chance someone can vectorize it? I'm having trouble with it being so small. Share this post Link to post Share on other sites
racinboy30 9 Posted March 29, 2011 Hi, I was sent this logo to redo for a racer in the area. Any chance someone can vectorize it? I'm having trouble with it being so small. Have them blow it up for you a bit, if you got it off a website I usually ask the teams to ask for the proper format artwork. Share this post Link to post Share on other sites
smithmotorsports99 1 Posted March 29, 2011 He didn't understand that at all. He thought bigger was just stretching a corner of the image. This is gonna be painful. Share this post Link to post Share on other sites
smithmotorsports99 1 Posted March 29, 2011 I think I found the welder Welder.bmp Share this post Link to post Share on other sites
autzenoise 2 Posted March 29, 2011 Well, got bored this morning and did this. It was done by hand, so don't expect perfection Hope it helps. candc.EPS Share this post Link to post Share on other sites
mark-s 1,126 Posted March 29, 2011 Thats the only way to do a bad image is by hand. Good job autzenoise. mark-s Share this post Link to post Share on other sites
smithmotorsports99 1 Posted March 30, 2011 ABSOLUTELY amazing! blew me away when I just got home to check it out. Thank you SO very much. I was stressing about this all day! Share this post Link to post Share on other sites
smithmotorsports99 1 Posted March 30, 2011 How did you do it by hand? I am asking because I think that is how I will have to do his number also. Share this post Link to post Share on other sites
autzenoise 2 Posted March 30, 2011 I just went through and created each layer by creating vector paths in Signblazer. And no prob I enjoy doing that stuff when I have no deadline lol Share this post Link to post Share on other sites
smithmotorsports99 1 Posted March 30, 2011 I will have to give it a try. I just haven't done much of this since I moved back to the East coast. Been spending all my time getting my race cars together and not spending the time toying around and learning. I find if you don't do it regularly, you tend to forget. Oops! Thanks again though. Huge relief! Share this post Link to post Share on other sites
smithmotorsports99 1 Posted April 3, 2011 any chance I can get help with the #7? I just need the 7 I can do the outline for sure.. thanks! Share this post Link to post Share on other sites
smithmotorsports99 1 Posted April 4, 2011 I tried with signblazer and flexi to try and trace or vector the gold portion of the # with no luck. I can somewhat get the red portion. But am trying to get the gold part so that I can redo the outline bigger or smaller if needed. The gold section has more defined points and curves than the red outline. Thanks! Share this post Link to post Share on other sites
smithmotorsports99 1 Posted April 5, 2011 I just downloaded inkscape again to try that program out. I must be losing my touch. I can win to save my life. Share this post Link to post Share on other sites
smithmotorsports99 1 Posted April 5, 2011 I think I got it. Hope it cuts out well Share this post Link to post Share on other sites