BandM 0 Posted December 2, 2010 First off I hope this was the right place to post this, I really wasn't sure where to post it. I am trying to do a design that is basically writing done in letterman font & then it has the distressed look. I am working in SignBlazer & will be cutting the design in vinyl. Does any one have any suggestions? Thanks. B&M Share this post Link to post Share on other sites
Jay2703 704 Posted December 2, 2010 I would try making it in Inkscape or Illustrator and see if there is some effect you can apply to it to make it what you are looking for. Share this post Link to post Share on other sites
BandM 0 Posted December 2, 2010 Sounds good, only problem is I don't know any thing about Inkscape. Could some one help me out or point me in a direction to get some tips? Such as putting the text on some what of a arch? 1 other question, can I do the designing in Inkscape & then import it into S-B & it will cut? Thanks much. Share this post Link to post Share on other sites
Spyder Graphix 0 Posted December 5, 2010 remember your going to have to pick out all the vinyl from the distressed look so be careful it could be a nightmare.. Share this post Link to post Share on other sites