doublerugged 0 Posted October 14, 2010 i own a jsi p-30 cutter and have signblazer elements for my software. i am now aware that this machine is a p-cut brand..or looks exactly like it. my problem is when i start a cut, the cutter starts and stops within a 1/4 second, and i get a message "standby" nothing else happens after that message. could this be a circuit board issue ? i have 2 other machines that run off the same software/pc and they all run fine. where can i get parts for this machine as jsi does not even sell them any longer any technical help out there ? Share this post Link to post Share on other sites
Jay2703 704 Posted October 14, 2010 What type of connections are you using? I had a P-Cut and had issues with the USB connection. I swithced to serial and the problems went away. I don't know if serial connection is an option but I would strongly recommend it. Jay Share this post Link to post Share on other sites
doublerugged 0 Posted October 14, 2010 on this model i only have a serial connection available. i wrote jsi and the response was..look elsewhere... -1 jsi customer now. just bought a p-cut 24 from uscutter, but i would still like to get my old one repaired and keep it as a backup machine. Share this post Link to post Share on other sites
hated paint 0 Posted October 26, 2010 While I have no real help repairing your machine I still had to post.I too bought a machine from jsi. It has never worked right.if yours is like mine it looks just like a p cut but its actually a king cut.Dont know that it matters but seems like the same machine.As far as any help from jsi forget it.Unless you spend a million dollars with them they dont want to be bothered with you.like I said mine has never worked. Ifound this forum bought a refine and have been cutting since Share this post Link to post Share on other sites
dacholiday 2 Posted November 27, 2010 This is a big problem with the jsi p-30 machine. I have it, and it does the same thing sometimes. It is more likelyto happen when you cut larger or multiple small repeats. I have found that if you setup using direct cut instead of cutmanager it works better. Also using fastest cut seems to help. Share this post Link to post Share on other sites