snowinyet 0 Posted December 13, 2007 Hello I was wonder is their a way to set my pcut so that when its done cutting it finishes at the end of the run instead of always going back to the starting point. so i don't have to run all of the material back threw the cutter agian to cut it off Thanks Share this post Link to post Share on other sites
Jay2703 704 Posted December 13, 2007 In cutter mode under setup is a check box to "Advance Page after job". Share this post Link to post Share on other sites
snowinyet 0 Posted December 13, 2007 Thanks I will try that David Share this post Link to post Share on other sites