DIRTRACER 2 Posted November 18, 2009 I have a p-cut, When I try to cut small letters like an a when I weed the center of the a pulls out. Am I doing something wrong? Thank you. Share this post Link to post Share on other sites
mr300s 1,272 Posted November 18, 2009 do you have your offset set at .025 ? Share this post Link to post Share on other sites
Guest kenya Posted November 18, 2009 Check the depth of your blade. Sometimes if it's too deep, it welds the vinyl to the backing. Share this post Link to post Share on other sites
DIRTRACER 2 Posted November 18, 2009 Thank you,Offset at .025. Maby I should bring blade out more, this is happning when I am trying to do small leters for etching. Share this post Link to post Share on other sites
mr300s 1,272 Posted November 18, 2009 Thank you,Offset at .025. Maby I should bring blade out more, this is happning when I am trying to do small leters for etching. You could also try slowing the speed way down unless you have one of the pcuts that dont go below 50? Share this post Link to post Share on other sites
DIRTRACER 2 Posted November 18, 2009 Thanks everyone,Yes I can slow way down. Share this post Link to post Share on other sites