jlbounds 0 Posted May 20, 2009 just recieved software.........is there a way that i can cut with it directly from corel draw?? and how do i register the software so i dont have to run the trial version i paid for it and i do not have access to the web from that computer Share this post Link to post Share on other sites
edge 67 Posted May 20, 2009 just recieved software.........is there a way that i can cut with it directly from corel draw?? and how do i register the software so i dont have to run the trial version i paid for it and i do not have access to the web from that computer If you're Corel is version 12 or newer, once you have it, SignCut, and the plotter driver installed; you should see a rocket in the upper toolbar of Corel that is used to "launch" the project to SignCut. As I understand SignCut, you will either need to get connected to the net, live with the limited version sans weeding tools, etc... , or pay xtra to purchase the dongle version to cut with it without an internet connection. Share this post Link to post Share on other sites