cbs1963 0 Posted April 29, 2009 I started cutting out a text design and now my LP 24 has started cutting each letter eight times each. I shut down the cutter and SBE and restarted, but it still retraces each letter cut eight times. Share this post Link to post Share on other sites
sailorpatp 0 Posted April 29, 2009 Sounds like you have several copies sitting on top of each other or you did an outline/in-line and didn't do a total weld. check the letters to make sure that their is just one copy. Share this post Link to post Share on other sites
cbs1963 0 Posted April 29, 2009 Where is the cutter cue? It should work like the print cue or does it? Share this post Link to post Share on other sites
sailorpatp 0 Posted April 29, 2009 I had that same problem when I printed several copies from SBE and then tried to cut-a-print. You didn't say that you were doing a cut-a-print. I think that the cut-a-print uses the print cue and then cuts what you printed. Try looking at the file and seeing if there are several lines in wire-frame. Share this post Link to post Share on other sites