wdcisco 0 Posted March 21, 2009 How do you setup the LP 48 w/ FlexiPro 8.1v? So far, I am having good luck with my new machine - except I can't print anything through FleXIpRO only Signblazer will work. Thanks for your help. Share this post Link to post Share on other sites
Guest fivestar Posted March 21, 2009 Use creation pcut drivers Share this post Link to post Share on other sites
wdcisco 0 Posted March 21, 2009 There are 8 or so different pcut drivers - does it matter which is selected? Share this post Link to post Share on other sites
Guest fivestar Posted March 21, 2009 Just start trying them until you find the one that works. I had a laserpoint and used it with Flexi Pro 8.1 using Creation Pcut driver but I can't remember which one I used. Try the CT630 first if it's listed, I can't remember if it is in there or not. Share this post Link to post Share on other sites
wdcisco 0 Posted March 22, 2009 Alright! Got my first cut Share this post Link to post Share on other sites
mb33139 0 Posted May 16, 2009 I'm curious... Are you connecting that LP via USB or serial port? Share this post Link to post Share on other sites
