Uncle Remus 0 Posted March 13, 2009 I have a copam 2500 & I have software that turns it into a contour cutter, now I am looking for a printer. I would like a printer that prints 20-24 inches, but do not want to spend $1000's on a printer & ink. What is a good printer&ink to start with? Also what about lamanating, I have seen some stuff called frog juice, i think thats the name. Is this a good alternative to a cold roll lamaniter? As always thanks for your input!! Share this post Link to post Share on other sites
Spyder Graphix 0 Posted March 13, 2009 You cant get the 2500 to contour cut. Its not just the software that makes it able to contour cut. Share this post Link to post Share on other sites
Uncle Remus 0 Posted March 13, 2009 You cant get the 2500 to contour cut. Its not just the software that makes it able to contour cut. I have personally already did it, so yes it can be done. It is a PITA to get it to work sometimes & you can't do a run of 100 decals or I havn't figured that out yet, but it will a make contour cut. Share this post Link to post Share on other sites